Decal Placement

INTRODUCTION: TAMMAR РNEW or REPLACEMENT DECALS
Please follow the below step to ensure correct placement of decals on your wheels. This document also has some handy tips for application.

 

TOOLS REQUIRED

Heat gun or hair dryer –¬†For removing old decal
Prepsol or Isocol- For cleaning rim surface
Cleaning Rags

 

 

Instructions
1/ Using a heat gun on low temperature or a hair dryer warm the old decal which will make for easier removal.

2/ Using surface cleaner make sure areas for the new decals is fully clean and free from any dust, wax, grease or dirt.

3/ Following the diagrams below to align and place the decals in the correct areas on the rim. Press firmly to ensure adhesion.

 

TIPS:
– For the larger BC decal remove the backing paper and place the lower edge of the decal on the rim. You will see there is a small lip on the rim edge, use this as your guide and it needs to sit inside this lip. You will need to slightly stretch to follow the curve of the rim. See below diagram

– When applying the decals make sure you start at one end and work your way to the other edge of the decal. This will prevent air bubble getting trapped.

classic

yes

Leave a Comment

;

Copyright 2017